Control Device Removal and Installation: Removal
CAUTION:
Make sure that parking brake is applied before removal/installation.
- Move selector lever to "N" position.
- Remove knob cover (1) below selector lever downward.
- Pull lock pin (3) out of selector lever knob (2).
- Remove selector lever knob (2).
- Remove cup holder, switch finisher, cluster lid C and A/T console finisher. Refer to "INSTRUMENT PANEL ASSEMBLY "
- Remove center console. Refer to "INSTRUMENT PANEL ASSEMBLY ".
- Disconnect A/T device harness connector.
- Remove control device assembly.
CAUTION:
Make sure that parking brake is applied before removal/installation.
- Disconnect lower lever of control device and control rod.
- Move selector lever to "N" position.
- Remove knob cover (1) below selector lever downward.
- Pull lock pin (3) out of selector lever knob (2).
- Remove selector lever knob (2).
- Remove cup holder, switch finisher, cluster lid C and A/T console finisher. Refer to "INSTRUMENT PANEL ASSEMBLY ".
- Remove center console. Refer to "INSTRUMENT PANEL ASSEMBLY ".
- Disconnect A/T device harness connector.
- Move selector lever to "P" position.
- Move driver side seat to the end.
- Remove one of floor carpet attachment clips (1).
- Remove control device assembly mounting dolts.
- Lift control device assembly (1). Then slide to the right till touching floor carpet.
- Pull control device assembly out in the right-slanting direction while pressing to the right.