LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Infiniti >> 2007 >> M35 Base >> Repair and Diagnosis >> Transmission >> Transfer Case >> Trouble Diagnosis >> AWD Control Unit Input/Output Signal Reference Values >> AWD Control Unit Inspection Table >> Specifications with CONSULT-II
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Specifications with CONSULT-II

AWD CONTROL UNIT INPUT/OUTPUT SIGNAL REFERENCE VALUES

Monitor item [Unit] Content Condition Display value
FR RH SENSOR [km/h] or [mph] Wheel speed (Front wheel right) Vehicle stopped 0.00 km/h (0.00 mph)
Vehicle running
CAUTION: Check air pressure of tire under standard condition.
Approximately equal to the indication on speedometer (Inside of ±10%)
FR LH SENSOR [km/h] or [mph] Wheel speed (Front wheel left) Vehicle stopped 0.00 km/h (0.00 mph)
Vehicle running
CAUTION: Check air pressure of tire under standard condition.
Approximately equal to the indication on speedometer (Inside of ±10%)
RR RH SENSOR [km/h] or [mph] Wheel speed (Rear wheel right) Vehicle stopped 0.00 km/h (0.00 mph)
Vehicle running
CAUTION: Check air pressure of tire under standard condition.
Approximately equal to the indication on speedometer (Inside of ±10%)
RR LH SENSOR [km/h] or [mph] Wheel speed (Rear wheel left) Vehicle stopped 0.00 km/h (0.00 mph)
Vehicle running
CAUTION: Check air pressure of tire under standard condition.
Approximately equal to the indication on speedometer (Inside of ±10%)
BATTERY VOLT [V] Power supply voltage for AWD control unit Ignition switch: ON Battery voltage
THRTL POS SEN [%] Throttle opening condition When depressing accelerator pedal (Value rises gradually in response to throttle position.) 0 - 100%
ETS SOLENOID [A] Monitored value of current at AWD solenoid Engine running
  • At idle speed
Approx. 0.000A
Engine running
  • When depressing accelerator pedal
Approx. 0.000 - 0.500A(1)
STOP LAMP SW [ON/OFF] Condition of brake pedal operation Brake pedal: Depressed ON
Brake pedal: Released OFF
ENG SPEED SIG [RUN/STOP] Condition of engine running Engine stopped
(Engine speed: Less than 400 rpm)
STOP
Engine running
(Engine speed: 400 rpm or more)
RUN
ETS ACTUATOR [ON/OFF] Operating condition of AWD actuator relay (integrated in AWD control unit) Engine stopped (Ignition switch: ON) OFF
Engine running ON
4WD WARN LAMP [ON/OFF] AWD warning lamp condition AWD warning lamp: ON ON
AWD warning lamp: OFF OFF
4WD MODE SW(2) [AUTO] Input condition from mode switch Always AUTO
4WD MODE MON [AUTO] Control status of AWD Engine running AUTO
DIS-TIRE MONI [mm] Improper size tire installed condition Vehicle running with normal size tire installed 0-4 mm
Vehicle running with improper size tire installed (Front/rear tire size difference, wear condition) 4-8 mm, 8-mm
P BRAKE SW [ON/OFF] Condition of parking brake Parking brake operated ON
Parking brake not operated OFF
(1) The values are changed by throttle opening and engine speed.
(2) Mode switch is not equipped, but displayed.