LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Infiniti >> 2007 >> QX56 AWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - Component Testing >> ASCD Brake Switch >> Component Inspection >> Stop Lamp Switch
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Stop Lamp Switch

  1. Turn ignition switch OFF.
  2. Disconnect stop lamp switch harness connector.
  3. Check harness continuity between stop lamp switch terminals 3 and 4 under the following conditions.
    TERMINALS CONTINUITY CHART

    Condition Continuity
    Brake pedal: Fully released Should not exist.
    Brake pedal: Slightly depressed Should exist.

    If NG, adjust stop lamp switch installation, refer to "BRAKE PEDAL ", and perform step  3 again.

    Fig 1: Checking Continuity Between Stop Lamp Switch Terminals 1 And 2
    G04920629Courtesy of NISSAN NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals