DTC Confirmation Procedure

PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

TESTING CONDITION:
- Perform "DTC WORK SUPPORT" when the fuel level is between 1/4 and 3/4 full, and vehicle is placed on flat level surface.
- Always perform test at a temperature of 0 to 30°C (32 to 86°F).
NOTE: Check that EVAP hoses are connected to EVAP canister purge volume control solenoid valve properly.

Do you have CONSULT-III?

YES: GO TO 2.

NO: GO TO 3.
PERFORM DTC CONFIRMATION PROCEDURE
With CONSULT-III
1. Turn ignition switch ON.
2. Turn ignition switch OFF and wait at least 10 seconds.
3. Turn ignition switch ON and select "DATA MONITOR" mode with CONSULT-III.
4. Check that the following conditions are met.
  COOLAN TEMP/S: 0 - 70°C (32 - 158°F)
  
  INT/A TEMP SE: 0 - 30°C (32 - 86°F)
5. Select "EVP SML LEAK P0442/P1442" of "EVAPORATIVE SYSTEM" in "DTC WORK SUPPORT" mode with CONSULT-III.
  Follow the instruction displayed.
  
  NOTE: If the engine speed cannot be maintained within the range displayed on the CONSULT-III screen, go to "BASIC INSPECTION : SPECIAL REPAIR REQUIREMENT ".
Which is displayed on CONSULT-III screen?

OK: INSPECTION END

NG: Go to "DIAGNOSIS PROCEDURE ".
PERFORM DTC CONFIRMATION PROCEDURE
With GST

NOTE: Be sure to read the explanation of Driving Pattern in "HOW TO SET SRT CODE " before driving vehicle.
1. Start engine.
2. Drive vehicle according to Driving Pattern.
3. Stop vehicle.
4. Turn ignition switch OFF, wait at least 10 seconds and then turn ON.
5. Check 1st trip DTC.
Is 1st trip DTC displayed?

YES-1: P0441: Go to "DIAGNOSIS PROCEDURE ".

YES-2: P0442: Go to "DIAGNOSIS PROCEDURE ".

NO: INSPECTION END