LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Infiniti >> 2008 >> EX35 Base, AWD >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System - DTCS P0451 To P1212 >> P0456 EVAP Control System >> DTC Logic >> DTC Confirmation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC Confirmation Procedure

  1. INSPECTION START

    Do you have CONSULT-III?

    Do you have CONSULT-III? 

    YES: GO TO 2.

    NO: GO TO  4.

  2. PRECONDITIONING

    If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

    NOTE: After repair, check that the hoses and clips are installed properly.

    TESTING CONDITION:

    • Open engine hood before conducting following procedure.
    • If any of following conditions are met just before the DTC confirmation procedure, leave the vehicle for more than 1 hour.
      • Fuel filler cap is removed.
      • Fuel is refilled or drained.
      • EVAP component parts is/are removed.
    • Before performing the following procedure, confirm that battery voltage is more than 11 V at idle.
    • Check that EVAP hoses are connected to EVAP canister purge volume control solenoid valve properly.

    GO TO 3.

  3. PERFORM DTC CONFIRMATION PROCEDURE

    With CONSULT-III 

    1. Turn ignition switch ON and select "DATA MONITOR" mode with CONSULT-III.
    2. Check the following conditions are met.

      FUEL LEVEL SE: 0.25 - 1.4 V 

      COOLAN TEMP/S: 0 - 32°C (32 - 90°F) 

      FUEL T/TMP SE: 0 - 35°C (32 - 95°F) 

      INT A/TEMP SE: More than 0°C (32°F) 

      If NG, turn ignition switch OFF and leave the vehicle in a cool place (soak the vehicle) or refilling/draining fuel until the output voltage condition of the "FUEL LEVEL SE" meets within the range above and leave the vehicle for more than 1 hour. Then start from step  1).

    3. Turn ignition switch OFF and wait at least 10 seconds.
    4. Turn ignition switch ON.
    5. Select "EVP V/S LEAK P0456/P1456" of "EVAPORATIVE SYSTEM" in "DTC WORK SUPPORT" mode with CONSULT-III.

      Follow the instruction displayed.

      NOTE: If the engine speed cannot be maintained within the range displayed on CONSULT-III screen, go to "BASIC INSPECTION : SPECIAL REPAIR REQUIREMENT ".

    Which is displayed on CONSULT-III screen? 

    OK: INSPECTION END

    NG: Go to "DIAGNOSIS PROCEDURE ".

  4. PERFORM COMPONENT FUNCTION CHECK

    Perform component function check. Refer to "COMPONENT FUNCTION CHECK ".

    NOTE: Use component function check to check the overall function of the EVAP very small leak function. During this check, a 1st trip DTC might not be confirmed.

    Is the inspection result normal? 

    YES: INSPECTION END

    NO: Go to "DIAGNOSIS PROCEDURE ".

scientia non olet · About LEMON Manuals