Component Inspection

1. Turn ignition switch OFF.
2. Reconnect all harness connectors disconnected.
3. Start engine and let it idle.
4. Check the voltage between ECM harness connector terminals under the following conditions.
   VOLTAGE SPECIFICATIONS
   
   

   ECM			Condition		Voltage (V)
   Connector	+	-
   	Terminal	Terminal
   F102	87	96	Steering wheel	Being turned	0.5 - 4.5
   				Not being turned	0.4 - 0.8

Is the inspection result normal? 

YES: INSPECTION END

NO: Replace power steering pressure sensor.