Component Inspection

1. Turn ignition switch OFF.
2. Disconnect electric throttle control actuator harness connector.
3. Check resistance between electric throttle control actuator terminals as follows.
   RESISTANCE SPECIFICATIONS
   
   

   Electric throttle control actuator		Resistance
   Bank	Terminals
   1	1 and 2	Approx. 1 - 15 Ω [at 25°C (77°F)]
   2	5 and 6

Is the inspection result normal? 

YES: INSPECTION END

NO: GO TO 2.

1. Replace malfunctioning electric throttle control actuator.
2. Go to "SPECIAL REPAIR REQUIREMENT ".

INSPECTION END