DTC Confirmation Procedure

If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

TESTING CONDITION: 

Before performing the following procedure, confirm that battery voltage is more than 11 V at idle. 

GO TO 2.

With CONSULT-III 

1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition switch ON.
3. Select "DATA MONITOR" mode with CONSULT-III.
4. Check the indication of "COOLAN TEMP/S".

   If it is between 4°C (39°F) and 36°C (97°F), go to the following steps.

   If it is below 4°C (39°F), warm engine up to more than 4°C (39°F) and retry from step  1.

   If it is above 36°C (97°F), cool engine down to less than 36°C (97°F) and retry from step  1.

5. Start engine and let it idle for 5 minutes.
6. Check 1st trip DTC.

With GST 

Follow the procedure "With CONSULT-III" above.

Is 1st trip DTC detected? 

YES: Go to "DIAGNOSIS PROCEDURE ".

NO: INSPECTION END