Component Inspection

1. Turn ignition switch OFF.
2. Reconnect all harness connectors disconnected.
3. Turn ignition switch ON.
4. Check the voltage ECM harness connector terminals as follows.
   VOLTAGE SPECIFICATIONS
   
   

   ECM			Condition		Voltage (V)
   Connector	+	-
   	Terminal	Terminal
   M107	97 (APP sensor 1)	100	Accelerator pedal	Fully released	0.5 - 1.0
   				Fully depressed	4.2 - 4.8
   	98 (APP sensor 2)	104		Fully released	0.25 - 0.50
   				Fully depressed	2.0 - 2.5

Is the inspection result normal? 

YES: INSPECTION END

NO: GO TO 2.

1. Replace accelerator pedal assembly.
2. Go to "SPECIAL REPAIR REQUIREMENT ".

INSPECTION END