Component Function Check

With CONSULT-III 

1. Turn ignition switch ON.
2. Select "BRAKE SW1" in "DATA MONITOR" mode with CONSULT-III.
3. Check "BRAKE SW1" indication under the following conditions.
   ICC BRAKE SWITCH FUNCTION
   
   

   Monitor item	Condition		Indication
   BRAKE SW1	Brake pedal	Slightly depressed	OFF
   		Fully released	ON

Without CONSULT-III 

1. Turn ignition switch ON.
2. Check the voltage between ECM harness connector terminals as follows.
   VOLTAGE SPECIFICATIONS
   
   

   ECM			Condition		Voltage (V)
   Connector	+	-
   	Terminal	Terminal
   M107	126 (ICC brake switch signal)	128	Brake pedal	Slightly depressed	Approx. 0
   				Fully released	Battery voltage

Is the inspection result normal? 

YES: INSPECTION END

NO: Go to "DIAGNOSIS PROCEDURE ".