Component Function Check

With CONSULT-III 

1. Turn ignition switch ON.
2. Select "BRAKE SW1" in "DATA MONITOR" mode with CONSULT-III.
3. Check "BRAKE SW1" indication under the following conditions.
   DATA MONITOR
   
   

   Monitor item	Condition		Indication
   BRAKE SW1	Brake pedal (A/T) Brake pedal and clutch pedal (M/T)	Slightly depressed	OFF
   		Fully released	ON

Without CONSULT-III 

1. Turn ignition switch ON.
2. Check the voltage between ECM harness connector and ground.
   TERMINALS VOLTAGE REFERENCE
   
   

   ECM		Ground	Condition		Voltage
   Connector	Terminal
   M107	126 (ICC brake switch signal)	Ground	Brake pedal (A/T) Brake pedal and clutch pedal (M/T)	Slightly depressed	Approx. 0V
   				Fully released	Battery voltage

Is the inspection result normal? 

YES: INSPECTION END

NO: Go to "DIAGNOSIS PROCEDURE ".