Component Inspection

1. Turn ignition switch OFF.
2. Reconnect all harness connectors disconnected.
3. Start engine and let it idle.
4. Check the voltage between ECM harness connector and ground under the following conditions.
   TERMINALS VOLTAGE REFERENCE
   
   

   ECM		Ground	Condition		Voltage
   Connector	Terminal
   F102	87	Ground	Steering wheel	Being turned	0.5 - 4.5V
   				Not being turned	0.4 - 0.8V

Is the inspection result normal? 

YES: INSPECTION END

NO: Replace power steering pressure sensor.