Component Function Check

PRECONDITIONING
Make sure that all of the following conditions are satisfied.

TESTING CONDITION
- Vehicle driven distance: More than 5, 000 km (3, 107 miles)
- Barometric pressure: 98.3 - 104.3 kPa (1.003 - 1.064 kg/cm² , 14.25 - 15.12 psi)
- Atmospheric temperature: 20 - 30°C (68 - 86°F)
- Engine coolant temperature: 75 - 95°C (167 - 203°F)
- Transmission: Warmed-up
  - For A/T models: After the engine is warmed up to normal operating temperature, drive vehicle until "ATF TEMP SE 1" (A/T fluid temperature sensor signal) indicates more than 60°C (140°F).
  - For M/T models: After the engine is warmed up to normal operating temperature, drive for 5 minutes.
- Electrical load: Not applied
  - Rear window defogger switch, air conditioner switch, lighting switch are OFF. Steering wheel is straight ahead.
- Engine speed: Idle
GO TO 2.
PERFORM SPEC IN DATA MONITOR MODE
$4 With CONSULT-III

NOTE: Perform "SPEC" in "DATA MONITOR" mode in maximum scale display.
1. Perform "BASIC INSPECTION : SPECIAL REPAIR REQUIREMENT ".
2. Select "B/FUEL SCHDL""A/F ALPHA-B1""A/F ALPHA-B2""MAS A/F SE-B1" and "MAS A/F SE-B2" in "SPEC" of "DATA MONITOR" mode with CONSULT-III.
3. Make sure that monitor items are within the SP value.
Is the measurement value within the SP value?

YES: INSPECTION END

NO: Go to "DIAGNOSIS PROCEDURE ".