Precautions for Removal and Installation of 4WAS Components
- Set the vehicle to the straight-ahead position when checking 4WAS and removing each component.
- Remove the battery terminal 10 minutes after turning the ignition switch OFF from ON and perform the removal of each component when removing the 4WAS front control unit.
- Perform the neutral position adjustment for the steering angle sensor after the replacement of steering angle sensor. Refer to "ADJUSTMENT OF STEERING ANGLE SENSOR NEUTRAL POSITION : SPECIAL REPAIR REQUIREMENT ".
- Refer to , "4WAS FRONT ACTUATOR NEUTRAL POSITION ADJUSTMENT : DESCRIPTION " for the replacement of 4WAS front control unit.
- Refer to , "4WAS FRONT ACTUATOR NEUTRAL POSITION ADJUSTMENT : DESCRIPTION " for the replacement of 4WAS front actuator.