LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Infiniti >> 2008 >> M35 Base >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System (VQ35DE) - Component And System Testing >> ICC Brake Switch >> Component Inspection >> Stop Lamp Switch
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Stop Lamp Switch

  1. Turn ignition switch OFF.
  2. Disconnect stop lamp switch harness connector.
  3. Check continuity between stop lamp switch terminals 1 and 2 under the following conditions.
    BRAKE PEDAL CONDITION CHART

    Condition Continuity
    Brake pedal: Fully released. Should not exist.
    Brake pedal: Slightly depressed. Should exist.
  4. If NG, adjust stop lamp switch installation, refer to "BRAKE PEDAL ", and perform step  3 again.
    Fig 1: Checking Continuity Between Stop Lamp Switch Terminals 1 And 2
    G05210078Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals