LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Infiniti >> 2008 >> QX56 AWD >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System - DTCS P1148 To P2A03 >> DTC P1554: Battery Current Sensor >> Component Inspection >> Battery Current Sensor
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Battery Current Sensor

  1. Reconnect harness connectors disconnected.
  2. Disconnect battery negative cable (1).
  3. Install jumper cable (A) between battery negative terminal and body ground.
  4. Turn ignition switch ON.
    Fig 1: Installing Jumper Cable Between Battery Negative Terminal And Body Ground
    G05739628Courtesy of NISSAN MOTOR CO., U.S.A.
  5. Check voltage between ECM terminal 71 (battery current sensor signal) and ground.

    Voltage: Approximately 2.5V 

  6. If NG, replace battery negative cable assembly.
    Fig 2: Checking Voltage Between ECM Terminal 71 (Battery Current Sensor Signal) And Ground
    G05739629Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals