DTC Confirmation Procedure

NOTE: If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

TESTING CONDITION:

Perform "DTC WORK SUPPORT" when the fuel level is between 1/4 and 3/4 full, and vehicle is placed on flat level surface .
Always perform test at a temperature of 0 to 30°C (32 to 86°F) .

WITH CONSULT-III

Turn ignition switch ON.
Turn ignition switch OFF and wait at least 10 seconds.
Turn ignition switch ON and select "DATA MONITOR" mode with CONSULT-III.
Check that the following conditions are met.
COOLAN TEMP/S: 0 - 70°C (32 - 158°F)

INT/A TEMP SE: 0 - 30°C (32 - 86°F)
Select "EVAP SML LEAK P0442/P1442" of "EVAPORATIVE SYSTEM" in "DTC WORK SUPPORT" mode with CONSULT-III.
Follow the instructions displayed.

NOTE: If the engine speed cannot be maintained within the range displayed on the CONSULT-III screen, go to "BASIC INSPECTION ".
Check that "OK" is displayed.

If "NG" is displayed, refer to "DIAGNOSIS PROCEDURE ".

NOTE: Check that EVAP hoses are connected to EVAP canister purge volume control solenoid valve properly.

WITH GST

NOTE: Be sure to read the explanation of "Driving Pattern" in "EMISSION-RELATED DIAGNOSTIC INFORMATION " before driving vehicle.

Start engine.
Drive vehicle according to "Driving Pattern" in "EMISSION-RELATED DIAGNOSTIC INFORMATION ".
Stop vehicle.
Turn ignition switch OFF, wait at least 10 seconds and then turn ON.
Select Service $07 with GST.
- If P0442 is displayed on the screen, go to "DIAGNOSIS PROCEDURE ".
- If P0441 is displayed on the screen, go to "DIAGNOSIS PROCEDURE ".