DTC Confirmation Procedure

NOTE:

If DTC P0456 is displayed with P0442, first perform the trouble diagnosis for DTC P0456 .
After repair, check that the hoses and clips are installed properly .
If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

TESTING CONDITION:

Open engine hood before conducting the following procedure .
If any of the following conditions are met just before the DTC confirmation procedure, leave the vehicle for more than 1 hour .
- Fuel filler cap is removed .
- Fuel is refilled or drained .
- EVAP component part/parts is/are removed .
Before performing the following procedure, confirm that battery voltage is more than 11 V at idle .

WITH CONSULT-III

Turn ignition switch ON and select "DATA MONITOR" mode with CONSULT-III.
Check that the following conditions are met.
FUEL LEVEL SE: 0.25 - 1.4 V

COOLAN TEMP/S: 0 - 32°C (32 - 90°F)

FUEL T/TMP SE: 0 - 35°C (32 - 95°F)

INT/A TEMP SE: More than 0°C (32°F)

If NG, turn ignition switch OFF and leave the vehicle in a cool place (soak the vehicle), or refill/drain fuel until the output voltage of the "FUEL LEVEL SE" meets within the range above and leave the vehicle for more than 1 hour. Then start from step 1.
Turn ignition switch OFF and wait at least 10 seconds.
Turn ignition switch ON.
Select "EVAP V/S LEAK P0456/P1456" of "EVAPORATIVE SYSTEM" in "DTC WORK SUPPORT" mode with CONSULT-III.
Follow the instructions displayed.
Check that "OK" is displayed.

If "NG" is displayed, go to "DIAGNOSIS PROCEDURE ".

NOTE:

If the engine speed cannot be maintained within the range displayed on CONSULT-III screen, go to "BASIC INSPECTION ".
Check that EVAP hoses are connected to EVAP canister purge volume control solenoid valve properly.