LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Infiniti >> 2010 >> M45 Base >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - DTCS P1550 To P2A03 >> DTC P2138 App Sensor >> Component Inspection >> Accelerator Pedal Position Sensor
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Accelerator Pedal Position Sensor

  1. Reconnect all harness connectors disconnected.
  2. Turn ignition switch ON.
  3. Check voltage between ECM terminals 106 (APP sensor 1 signal), 98 (APP sensor 2 signal) and ground under the following conditions.
    VOLTAGE CONNECTOR TERMINALS REFERENCE CHART

    Terminal Accelerator pedal Voltage
    106
    (Accelerator pedal position sensor 1)    		 Fully released 0.4 - 1.1 V
    Fully depressed 3.7 - 4.8 V
    98
    (Accelerator pedal position sensor 2)    		 Fully released 0.20 - 0.55 V
    Fully depressed 1.85 - 2.40 V
    Fig 1: Checking ECM Connector Voltage
    G04900719Courtesy of NISSAN MOTOR CO., U.S.A.
  4. If NG, replace accelerator pedal assembly and go to next step.
  5. Perform "ACCELERATOR PEDAL RELEASED POSITION LEARNING ".
  6. Perform "THROTTLE VALVE CLOSED POSITION LEARNING ".
  7. Perform "IDLE AIR VOLUME LEARNING ".
scientia non olet · About LEMON Manuals