With CONSULT-III
- Perform "ACCELERATOR PEDAL RELEASED POSITION LEARNING ".
- Perform "THROTTLE VALVE CLOSED POSITION LEARNING ".
- Start engine and warm it up to normal operating temperature.
- Check that all items listed under the topic PREPARATION (previously mentioned) are in good order.
- Select "IDLE AIR VOL LEARN" in "WORK SUPPORT" mode.
- Touch "START" and wait 20 seconds.
- Check that "CMPLT" is displayed on CONSULT-III screen. If "CMPLT" is not displayed, Idle Air Volume Learning will not be carried out successfully. In this case, find the cause of the incident by referring to the DIAGNOSTIC PROCEDURE below.
- Rev up engine two or three times and check that idle speed and ignition timing are within the specifications.
ITEM SPECIFICATION CHART
| ITEM | SPECIFICATION |
|---|---|
| Idle speed | 650 ± 50 RPM (in P or N position) |
| Ignition timing | 12 ± 5°BTDC (in P or N position) |