Component Inspection
WARNING: This page is about a different car, the 2010 Infiniti M35. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK SNOW MODE SWITCH-I
- Turn ignition switch OFF.
- Disconnect snow mode switch harness connector.
- Check the continuity between snow mode switch terminals under the following conditions.CONNECTOR TERMINAL CONTINUITY CHART
Terminals Condition Continuity 1 and 4 Snow mode switch ON Existed OFF Not Existed Is the inspection result normal?
YES: GO TO 2.
NO: Replace snow mode switch.
- CHECK SNOW MODE SWITCH-II
Check the continuity between snow mode switch terminals under the following conditions.
TERMINAL CONTINUITY CHARTTerminals (Polarity) Continuity 2 (+) - 4 (-) Existed 4 (+) - 2 (-) Not Existed Is the inspection result normal?
YES: INSPECTION END
NO: Replace snow mode switch.