Diagnosis Procedure
- CHECK ICC BRAKE SWITCH POWER SUPPLY CIRCUIT
- Turn ignition switch OFF.
- Disconnect ICC brake switch harness connector.
- Turn ignition switch ON.
- Check the voltage between ICC brake switch harness connector and ground.VOLTAGE REFERENCE
ICC brake switch Ground Voltage Connector Terminal E114 1 Ground Battery voltage Is the inspection result normal?
YES: GO TO 3.
NO: GO TO 2.
- DETECT MALFUNCTIONING PART
Check the following.
- Fuse block (J/B) connector E103
- 10A fuse (No. 3)
- Harness for open or short between ICC brake switch and fuse
Repair open circuit or short to ground in harness or connectors.
- CHECK ICC BRAKE SWITCH INPUT SIGNAL CIRCUIT FOR OPEN AND SHORT
- Turn ignition switch OFF.
- Disconnect ECM harness connector.
- Check the continuity between ICC brake switch harness connector and ECM harness connector.CONTINUITY REFERENCE
ICC brake switch ECM Continuity Connector Terminal Connector Terminal E114 2 M107 126 Existed - Also check harness for short to ground and short to power.
Is the inspection result normal?
YES: GO TO 5.
NO: GO TO 4.
- DETECT MALFUNCTIONING PART
Check the following.
- Harness connectors E106, M6
- Harness for open or short between ICC brake switch and ECM
Repair open circuit, short to ground or short to power in harness or connectors.
- CHECK ICC BRAKE SWITCH
Refer to "COMPONENT INSPECTION (ICC BRAKE SWITCH) ".
Is the inspection result normal?
YES: GO TO 6.
NO: Replace ICC brake switch.
- CHECK INTERMITTENT INCIDENT
Refer to "INTERMITTENT INCIDENT ".
INSPECTION END