Component Function Check

TESTING CONDITION: 

• Before performing the following procedure, confirm that battery voltage is more than 12.8 V at idle. 
• Before performing the following procedure, confirm that all load switches and A/C switch are turned OFF. 

  GO TO 2.

With CONSULT-III 

1. Start engine and let it idle.
2. Select "BAT CUR SEN" in "DATA MONITOR" mode with CONSULT-III.
3. Check "BAT CUR SEN" indication for 10 seconds.

   "BAT CUR SEN" should be above 2, 300 mV at least once. 

Without CONSULT-III 

1. Start engine and let it idle.
2. Check the voltage between ECM harness connector terminals as per the following.
   VOLTAGE REFERENCE
   
   

   ECM			Voltage (V)
   Connector	+	-
   	Terminal	Terminal
   F102	91 (Battery current sensor signal)	95	Above 2.3 at least once

   Is the inspection result normal? 

   YES: INSPECTION END

   NO: Go to "DIAGNOSIS PROCEDURE "