Component Function Check

WITH CONSULT-III

1. Turn ignition switch ON.
2. Select "BRAKE SW1" in "DATA MONITOR" mode with CONSULT-III.
3. Check "BRAKE SW1" indication under the following conditions.
   MONITOR ITEM CONDITION
   
   

   Monitor item	Condition		Indication
   BRAKE SW1 (ASCD brake switch)	Brake pedal	Slightly depressed	OFF
   		Fully released	ON

WITHOUT CONSULT-III

1. Turn ignition switch ON.
2. Check the voltage between ECM harness connector terminals as per the following.
   VOLTAGE SPECIFICATION
   
   

   ECM			Condition		Voltage (V)
   Connector	+	-
   	Terminal	Terminal
   E80	147 (ASCD brake switch signal)	175	Brake pedal	Slightly depressed	Approx. 0
   				Fully released	Battery voltage

   Is the inspection result normal? 

   YES: INSPECTION END

   NO: Go to "DIAGNOSIS PROCEDURE ".