2WD: Removal and Installation: Installation

Note the following, and install in the reverse order of removal.

• Do not allow engine mounting insulator to be damage and careful no oil gets on it.
• For a location with a positioning pin, insert it securely into hole of mating part.
• For a part with a specified installation orientation, refer to component figure in "2WD: EXPLODED VIEW ".
• When installing engine mounting bracket (RH and LH) on cylinder block, tighten two upper bolts [shown as (B) in the figure] first. Then tighten two lower bolts [shown as (C) in the figure].
  Fig 1: Identifying Engine Mounting Bracket Bolts

  Courtesy of NISSAN NORTH AMERICA, INC.
• Check all engine mounting insulators are seated properly, and then tighten mounting nuts.
• Tighten rear engine mounting member bolts in numerical order as shown in the figure.
  Fig 2: Identifying Rear Engine Mounting Member Bolts Tightening Order

  Courtesy of NISSAN NORTH AMERICA, INC.