Component Function Check

WARNING: This page is about a different car, the 2012 Infiniti FX35. However, it is still accessible from the selected car via links, so may be relevant.

INSPECTION START
Turn ignition switch OFF, and restart engine.

Does the engine start?

YES-1: With CONSULT: GO TO 2.

YES-2: Without CONSULT: GO TO 3.

NO: Proceed to "DIAGNOSIS PROCEDURE ".
CHECK IGNITION SIGNAL FUNCTION
With CONSULT
1. Perform "POWER BALANCE" in "ACTIVE TEST" mode with CONSULT.
2. Check that each circuit produces a momentary engine speed drop.
  Is the inspection result normal?
  
  YES: INSPECTION END
  
  NO: Proceed to "DIAGNOSIS PROCEDURE ".

CHECK IGNITION SIGNAL FUNCTION

Without CONSULT

Let engine idle.

Read the voltage signal between ECM harness connector terminals as per the following conditions with an oscilloscope:

ECM				Voltage signal
+		-
Connector	Terminal	Connector	Terminal
F101	11	M107	128	Courtesy of NISSAN NORTH AMERICA, INC.
	12
	15
	16
	19
	20

NOTE: The pulse cycle changes depending on rpm at idle.

Is the inspection result normal?

YES: INSPECTION END

NO: Proceed to "DIAGNOSIS PROCEDURE ".