VCM : Work Procedure

WARNING: This page is about a different car, the 2011 Nissan Leaf. However, it is still accessible from the selected car via links, so may be relevant.

PERFORM VCM RECOMMUNICATING FUNCTION
1. Install VCM.
2. Contact backside of registered Intelligent key* to power switch while brake pedal is depressed, then turn power switch to the ON position.
  *: To perform this step, use the key that is used before performing VCM replacement.
3. Maintain power switch in the ON position for at least 5 seconds.
4. Turn power switch to the OFF position.
5. Check that the vehicle can be set to READY.
  Go to 2.
PERFORM ADDITIONAL SERVICE WHEN REPLACING VCM
Perform the following procedure "REMOVAL AND INSTALLATION ".

END