Ready Set Condition Table By Power Switch Operation
WARNING: This page is about a different car, the 2011 Nissan Leaf. However, it is still accessible from the selected car via links, so may be relevant.
The vehicle can be set to READY by the following operations.
For details for the power supply position, refer to "POWER DISTRIBUTION SYSTEM : SYSTEM DESCRIPTION ".
NOTE:
- When an Intelligent Key is within the detection area of inside key antenna and when Intelligent Key backside is contacted to power switch, it is equivalent to the operations below.
- When setting the vehicle to READY, the BCM monitors READY set conditions,
- Brake pedal operating condition
- Shift position
- Vehicle speed
Vehicle speed: less than 4 km/h (2.5 MPH)
POWER SWITCH OPERATION FREQUENCY REFERENCE
| Vehicle condition | Power switch operation frequency | ||
|---|---|---|---|
| Shift position | Brake pedal operation condition | ||
| OFF → ACC | - | Not depressed | 1 |
| OFF → ACC → ON | - | Not depressed | 2 |
| OFF → ACC → ON → OFF | - | Not depressed | 3 |
| OFF → READY ACC → READY ON → READY |
P or N | Depressed | 1 |
| READY → OFF | - | - | 1 |
Vehicle speed: 4 km/h (2.5 MPH) or more
POWER SWITCH OPERATION FREQUENCY REFERENCE
| Vehicle condition | Power switch operation frequency | ||
|---|---|---|---|
| Shift position | Brake pedal operation condition | ||
| READY → ACC | - | - | Emergency stop operation |
| ACC → READY (Return operation after emergency stop operation while driving) | N position | - | 1 |
Emergency stop operation
- Press and hold the power switch for 2 seconds or more.
- Press the power switch 3 times or more within 1.5 seconds.