HPCM: Work Procedure

PERFORM HPCM RECOMMUNICATING FUNCTION
1. Install HPCM.
2. Contact backside of registered Intelligent key* to push-button ignition switch while brake pedal is depressed, then turn ignition switch ON.
  *: To perform this step, use the key that is used before performing HPCM replacement.
3. Maintain ignition switch in the ON position for at least 5 seconds.
4. Turn ignition switch OFF.
5. Check that the vehicle can be set to READY.
: GO TO 2.
PERFORM ADDITIONAL SERVICE WHEN REPLACING HPCM
Perform the following procedure, HBC-98, "Work Procedure".

: END