Ready Set Condition Table By Push-Button Ignition Switch Operation
The vehicle can be set to READY by the following operations.
NOTE:
- When an Intelligent Key is within the detection area of inside key antenna and when Intelligent Key backside is contacted to push-button ignition switch, it is equivalent to the operations below.
- When setting the vehicle to READY, the BCM monitors the following conditions.
- Brake pedal operating condition
- Selector lever position
- Vehicle speed
VEHICLE SPEED - LESS THAN 4 KM/H (2.5 MPH)
| Vehicle condition | Push-button ignition switch operation frequency | ||
|---|---|---|---|
| Selector lever | Brake pedal operation condition | ||
| OFF → ACC | - | Not depressed | 1 |
| OFF → ACC → ON | - | Not depressed | 2 |
| OFF → ACC → ON → OFF | - | Not depressed | 3 |
| OFF → READY ACC → READY ON → READY |
P or N position | Depressed | 1 |
| READY → OFF | - | - | 1 |
VEHICLE SPEED - 4 KM/H (2.5 MPH) OR MORE
| Vehicle condition | Push-button ignition switch operation frequency | ||
|---|---|---|---|
| Selector lever | Brake pedal operation condition | ||
| READY → ACC | - | - | Emergency stop operation |
| ACC → READY (Return operation after emergency stop operation while driving) |
N position | - | 1 |
Emergency stop operation
- Press and hold the push-button ignition switch for 2 seconds or more.
- Press the push-button ignition switch 3 times or more within 1.5 seconds.