Component Function Check

ⓧ Without CONSULT 

1. Lift up drive wheels.
2. Perform "INSPECTION MODE 5". Refer to "DESCRIPTION ".
3. Start engine (VDC switch OFF) and warm it up to normal operating temperature.
4. Turn ignition switch OFF and wait at least 10 seconds.
5. Turn ignition switch ON.
6. Turn ignition switch OFF and wait at least 10 seconds.
7. Perform "INSPECTION MODE 5". Refer to "DESCRIPTION ".
8. Start engine and wait at least 70 seconds.
9. Set voltmeter probes to ECM harness connector terminals as per the following.

   ECM
   Connector	+	-
   	Terminal	Terminal
   M107	102 (EVAP control system pressure sensor signal)	112

10. Check EVAP control system pressure sensor value at idle speed and note it.
11. Establish and maintain the following conditions for at least 1 minute.

    Air conditioner switch	ON
    Headlamp switch	ON
    Rear window defogger switch	ON
    Engine speed	Approx. 3, 000 RPM
    Gear position	Any position other than P, N or R

12. Verify that EVAP control system pressure sensor value stays 0.1 V less than the value at idle speed (measured at step  8) for at least 1 second.

    Is the inspection result normal? 

    YES: INSPECTION END

    NO: Go to "DIAGNOSIS PROCEDURE ".