LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Infiniti >> 2012 >> M35h >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - DTCS P0171 To P0463 >> DTC P0452: EVAP Control System Pressure Sensor >> Component Inspection
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Component Inspection

  1. CHECK EVAP CONTROL SYSTEM PRESSURE SENSOR
    1. Turn ignition switch OFF.
    2. Remove EVAP control system pressure sensor with its harness connector.

      Always replace O-ring with a new one. 

    3. Install a vacuum pump to EVAP control system pressure sensor.
    4. Turn ignition switch ON and check output voltage between ECM harness connector terminals under the following conditions.
      ECM Condition [Applied vacuum kPa (kg/cm2 , psi)] Voltage (V)
      Connector + -
      Terminal Terminal
      M107 102 112 Not applied 0.5 - 4.6
      -26.7 (-0.272, -3.87) 2.1 to 2.5 lower than above value
      CAUTION:
      • Always calibrate the vacuum pump gauge when using it.
      • Never apply below -93.3 kPa (-0.952 kg/cm2 , -13.53 psi) or pressure over 101.3 kPa (1.033 kg/cm2 , 14.69 psi).

      Is the inspection result normal? 

      YES: INSPECTION END

      NO: Replace EVAP control system pressure sensor

scientia non olet · About LEMON Manuals