DTC Confirmation Procedure

If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition switch ON.
3. Turn ignition switch OFF and wait at least 10 seconds.

   : GO TO 2.

◦ With CONSULT

1. Perform "INSPECTION MODE 5". Refer to "DESCRIPTION ".
2. Start engine and wait at least 5 seconds.
3. Perform "All DTC Reading".
4. Check DTC of "MOTOR CONTROL".

   Is the DTC U0100, U0101, U0111 or U0293 detected? 

   YES: GO TO 3.

   NO-1 (DTC U0100, U0101, U0111 or U0293 is stored in "Motor Control" at the time of receiving.): GO TO 3.

   NO-2 (Repaired after performing "DIAGNOSIS PROCEDURE "): INSPECTION END

◦ With CONSULT

1. Perform "CAN Diagnosis".
2. Check diagnosis results.

   : Go to "DIAGNOSIS PROCEDURE ".