Component Function Check

PRECONDITIONING
1. Perform INSPECTION MODE 5. Refer to "DESCRIPTION ".
2. Start engine.
3. Make sure that all of the following conditions are satisfied.
  TESTING CONDITION
  - Vehicle driven distance: More than 5, 000 km (3, 107 miles)
  - Barometric pressure: 98.3 - 104.3 kPa (1.003 - 1.064 kg/cm² , 14.25 - 15.12 psi)
  - Atmospheric temperature: 20 - 30°C (68 - 86°F)
  - Engine coolant temperature: 75 - 95°C (167 - 203°F)
  - Transmission: Warmed-up
  - After the engine is warmed up to normal operating temperature, drive vehicle until "ATF TEMP 1" (A/T fluid temperature sensor signal) indicates more than 60°C (140°F).
  - Electrical load: Not applied
  - Rear window defogger switch, air conditioner switch, lighting switch are OFF. Steering wheel is straight ahead.
  - Engine speed: Idle
    : GO TO 2.
PERFORM SPEC IN DATA MONITOR MODE
◦ With CONSULT

NOTE: Perform "SPEC" in "DATA MONITOR" mode of "ENGINE" in maximum scale display.
1. Perform "WORK PROCEDURE ".
2. Select "B/FUEL SCHDL", "A/F ALPHA-B1", "A/F ALPHA-B2", "MAS A/F SE-B1" and "MAS A/F SE-B2" in "SPEC" in "DATA MONITOR" mode of "ENGINE" with CONSULT.
3. Make sure that monitor items are within the SP value.
  Is the measurement value within the SP value?
  
  YES: INSPECTION END
  
  NO: Go to "DIAGNOSIS PROCEDURE ".