Component Function Check

1. Turn ignition switch OFF. '
2. Perform "INSPECTION MODE 5". Refer to "DESCRIPTION ".
3. Start engine.

   Does the engine start? 

   YES-1: With CONSULT: GO TO 2.

   YES-2: Without CONSULT: GO TO  3.

   No: Go to "DIAGNOSIS PROCEDURE ".

◦ With CONSULT 

1. Perform "POWER BALANCE" in "ACTIVE TEST" mode of "ENGINE" with CONSULT.
2. Make sure that each circuit produces a momentary engine speed drop.

   Is the inspection result normal? 

   YES: INSPECTION END

   NO: Go to "DIAGNOSIS PROCEDURE ".

ⓧ Without CONSULT 

1. Let engine idle.
2. Read the voltage signal between ECM harness connector terminals under the following conditions with an oscilloscope.

   ECM				Voltage signal
   +		-
   Connector	Terminal	Connector	Terminal
   F101	11	M107	128	Courtesy of NISSAN NORTH AMERICA, INC.
   	12
   	15
   	16
   	19
   	20

   NOTE: The pulse cycle changes depending on RPM at idle.

   Is the inspection result normal? 

   YES: INSPECTION END

   NO: Go to "DIAGNOSIS PROCEDURE ".