April 5, 2026: LEMON Manuals is launched! Read the announcement.

Component Inspection

CHECK ACCELERATOR PEDAL POSITION SENSOR

Turn ignition switch OFF.
Reconnect all harness connectors disconnected.
Turn ignition switch ON.

Check the voltage ECM harness connector terminals as per the following.

ECM			Condition		Voltage (V)
Connector	+	-
Connector	Terminal	Terminal
M107	97 (APP sensor 1)	100	Accelerator pedal	Fully released	0.45 - 1.0
	97 (APP sensor 1)	100		Fully depressed	4.2 - 4.8
	98 (APP sensor 2)	104		Fully released	0.22 - 0.50
	98 (APP sensor 2)	104		Fully depressed	2.1 - 2.5

Is the inspection result normal?

YES: INSPECTION END

NO: GO TO 2.

REPLACE ACCELERATOR PEDAL ASSEMBLY
1. Replace accelerator pedal assembly.
2. Go to "SPECIAL REPAIR REQUIREMENT ".
  : INSPECTION END