ECM: Work Procedure

WARNING: This page is about a different car, the 2013 Infiniti M56 and 2013 Infiniti M37. However, it is still accessible from the selected car via links, so may be relevant.

PERFORM ECM RECOMMUNICATING FUNCTION
1. Install ECM.
2. Contact backside of registered Intelligent key* to push-button ignition switch, then turn power supply position to ON.
  *: To perform this step, use the key that is used before performing ECM replacement.
3. Maintain power supply position in the ON position for at least 5 seconds.
4. Turn power supply position to OFF.
5. Check that the engine starts.
  : GO TO 2.
PERFORM ADDITIONAL SERVICE WHEN REPLACING ECM
Perform the following procedure.
- VQ37VHR: "WORK PROCEDURE "
- VK56VD: "WORK PROCEDURE "
  : END