Data Monitor: Notes
NOTE:
The following table includes information (items) inapplicable to this vehicle. For information (items) applicable to this vehicle, refer to
CONSULT display items.
| X: Standard, -: Not applicable, O: Option | |||||
|---|---|---|---|---|---|
| Monitored item (Unit) | Monitor Item Selection | Remarks | |||
| ECU INPUT SIGNALS | MAIN SIGNALS | SELECTION FROM ITEM | |||
| VHCL/S SE-A/T | (km/h or mph) | X | X | O | Displays the vehicle speed calculated by the TCM from the output shaft revolution. |
| ESTM VSP SIG | (km/h or mph) | X | - | O | Displays the vehicle speed signal received via CAN communication. |
| OUTPUT REV | (RPM) | X | X | O | Displays the output speed calculated from the pulse signal of output speed sensor. |
| INPUT SPEED | (RPM) | X | X | O | Displays the input speed calculated from front sun gear revolution and front carrier revolution. |
| F SUN GR REV | (RPM) | - | - | O | Displays the front sun gear revolution calculated from the pulse signal of input speed sensor 1. |
| F CARR GR REV | (RPM) | - | - | O | Displays the front carrier gear revolution calculated from the pulse signal of input speed sensor 2. |
| ENGINE SPEED | (RPM) | X | X | O | Displays the engine speed received via CAN communication. |
| TC SLIP SPEED | (RPM) | - | X | O | Displays the revolution difference between input speed and engine speed. |
| ACCELE POSI | (0.0/8) | X | - | O | Displays the accelerator position estimated value received via CAN communication. |
| THROTTLE POSI | (0.0/8) | X | X | O | Displays the throttle position received via CAN communication. |
| ATF TEMP 1 | (°C or °F) | X | X | O | Displays the ATF temperature of oil pan calculated from the signal voltage of A/T fluid temperature sensor. |
| ATF TEMP 2 | (°C or °F) | X | X | O | Displays the ATF temperature estimated value of torque converter outlet calculated from the signal voltage of A/T fluid temperature sensor. |
| ATF TEMP SE 1 | (V) | - | - | O | Displays the signal voltage of A/T fluid temperature sensor. |
| BATTERY VOLT | (V) | X | - | O | Displays the power supply voltage of TCM. |
| LINE PRES SOL | (A) | - | X | O | Displays the command current from TCM to the line pressure solenoid. |
| TCC SOLENOID | (A) | - | X | O | Displays the command current from TCM to the torque converter clutch solenoid. |
| L/B SOLENOID | (A) | - | X | O | Displays the command current from TCM to the low brake solenoid. |
| FR/B SOLENOID | (A) | - | X | O | Displays the command current from TCM to the front brake solenoid. |
| HLR/C SOL | (A) | - | X | O | Displays the command current from TCM to the high and low reverse clutch solenoid. |
| I/C SOLENOID | (A) | - | X | O | Displays the command current from TCM to the input clutch solenoid. |
| D/C SOLENOID | (A) | - | X | O | Displays the command current from TCM to the direct clutch solenoid. |
| 2346/B SOL | (A) | - | X | O | Displays the command current from TCM to the 2346 brake solenoid. |
| L/P SOL MON | (A) | - | - | O | Monitors the command current from TCM to the line pressure solenoid, and displays the monitor value. |
| TCC SOL MON | (A) | - | - | O | Monitors the command current from TCM to the torque converter clutch solenoid, and displays the monitor value. |
| L/B SOL MON | (A) | - | - | O | Monitors the command current from TCM to the low brake solenoid, and displays the monitor value. |
| FR/B SOL MON | (A) | - | - | O | Monitors the command current from TCM to the front brake solenoid, and displays the monitor value. |
| HLR/C SOL MON | (A) | - | - | O | Monitors the command current from TCM to the high and low reverse clutch solenoid, and displays the monitor value. |
| I/C SOL MON | (A) | - | - | O | Monitors the command current from TCM to the input clutch solenoid, and displays the monitor value. |
| D/C SOL MON | (A) | - | - | O | Monitors the command current from TCM to the direct clutch solenoid, and displays the monitor value. |
| 2346/B SOL MON | (A) | - | - | O | Monitors the command current from TCM to the 2346 brake solenoid, and displays the monitor value. |
| GEAR RATIO | - | X | O | Displays the gear ratio calculated from input speed and output speed. | |
| ENGINE TORQUE | (Nm) | - | - | O | Displays the engine torque estimated value received via CAN communication. |
| ENG TORQUE D | (Nm) | - | - | O | Displays the engine torque estimated value reflected the requested torque of each control unit received via CAN communication. |
| INPUT TRQ S | (Nm) | - | - | O | Displays the input torque using for the oil pressure calculation process of shift change control. |
| INPUT TRQ L/P | (Nm) | - | - | O | Displays the input torque using for the oil pressure calculation process of line pressure control. |
| TRGT PRES L/P | (kPa, kg/cm2 or psi) | - | - | O | Displays the target oil pressure value of torque converter clutch solenoid valve calculated by the oil pressure calculation process of lock-up control. |
| TRGT PRES TCC | (kPa, kg/cm2 or psi) | - | - | O | Displays the target oil pressure value of torque converter clutch solenoid valve calculated by the oil pressure calculation process of shift change control. |
| TRGT PRES L/B | (kPa, kg/cm2 or psi) | - | - | O | Displays the target oil pressure value of low brake solenoid valve calculated by the oil pressure calculation process of shift change control. |
| TRGT PRE FR/B | (kPa, kg/cm2 or psi) | - | - | O | Displays the target oil pressure value of front brake solenoid valve calculated by the oil pressure calculation process of shift change control. |
| TRG PRE HLR/C | (kPa, kg/cm2 or psi) | - | - | O | Displays the target oil pressure value of high and low reverse clutch solenoid valve calculated by the oil pressure calculation process of shift change control. |
| TRGT PRES I/C | (kPa, kg/cm2 or psi) | - | - | O | Displays the target oil pressure value of input clutch solenoid valve calculated by the oil pressure calculation process of shift change control. |
| TRGT PRES D/C | (kPa, kg/cm2 or psi) | - | - | O | Displays the target oil pressure value of direct clutch solenoid valve calculated by the oil pressure calculation process of shift change control. |
| TRG PRE 2346/B | (kPa, kg/cm2 or psi) | - | - | O | Displays the target oil pressure value of 2346 brake solenoid valve calculated by the oil pressure calculation process of shift change control. |
| SHIFT PATTERN | - | - | O | Displays the gear change data using the shift pattern control. | |
| VEHICLE SPEED | (km/h or mph) | - | - | O | Displays the vehicle speed for control using the control of TCM. |
| G SEN SLOPE | (%) | X | - | O | Displays the inclination angle calculated by the decel G sensor signal received via CAN communication. |
| RANGE SW 4 | (ON/OFF) | X | - | O | Displays the operation status of transmission range switch 4. |
| RANGE SW 3 | (ON/OFF) | X | - | O | Displays the operation status of transmission range switch 3. |
| RANGE SW 2 | (ON/OFF) | X | - | O | Displays the operation status of transmission range switch 2. |
| RANGE SW 1 | (ON/OFF) | X | - | O | Displays the operation status of transmission range switch 1. |
| SFT DWN ST SW | (ON/OFF) | X | - | O | Displays the operation status of paddle shifter (down switch). |
| SFT UP ST SW | (ON/OFF) | X | - | O | Displays the operation status of paddle shifter (up switch). |
| DOWN SW LEVER | (ON/OFF) | X | - | O | Displays the operation status of selector lever (down switch). |
| UP SW LEVER | (ON/OFF) | X | - | O | Displays the operation status of selector lever (up switch). |
| NON M-MODE SW | (ON/OFF) | X | - | O | Displays whether the selector lever is in any position other than manual shift gate position. |
| MANU MODE SW | (ON/OFF) | X | - | O | Displays whether the selector lever is in the manual shift gate position. |
| TOW MODE SW | (ON/OFF) | - | - | O |
|
| DS RANGE | (ON/OFF) | - | - | O |
|
| 1 POSITION SW | (ON/OFF) | X | - | O |
|
| OD CONT SW | (ON/OFF) | X | - | O |
|
| BRAKESW | (ON/OFF) | X | - | O | Displays the reception status of stop lamp switch signal received via CAN communication. |
| POWERSHIFT SW | (ON/OFF) | X | - | O |
|
| ASCD-OD CUT | (ON/OFF) | X | - | O | Displays the reception status of ASCD OD cancel request signal received via CAN communication. |
| ASCD-CRUISE | (ON/OFF) | X | - | O | Displays the reception status of ASCD operation signal received via CAN communication. |
| ABS SIGNAL | (ON/OFF) | X | - | O | Displays the reception status of ABS operation signal received via CAN communication. |
| TCS GR/P KEEP | (ON/OFF) | X | - | O | Displays the reception status of TCS gear keep request signal received via CAN communication. |
| TCS SIGNAL 2 | (ON/OFF) | X | - | O | Displays whether the reception value of A/T shift schedule change demand signal received via CAN communication is "cold". |
| TCS SIGNAL 1 | (ON/OFF) | X | - | O | Displays whether the reception value of A/T shift schedule change demand signal received via CAN communication is "warm". |
| LOW/B PARTS | (FAIL/NOTFAIL) | - | - | O | Displays whether the identified malfunction point judged by TCM is the related parts of low brake. |
| HC/IC/FRB PARTS | (FAIL/NOTFAIL) | - | - | O | Displays whether the identified malfunction point judged by TCM is the related parts of high and low reversed clutch, input clutch or front brake. |
| IC/FRB PARTS | (FAIL/NOTFAIL) | - | - | O | Displays whether the identified malfunction point judged by TCM is the related parts of input clutch or front brake. |
| HLR/C PARTS | (FAIL/NOTFAIL) | - | - | O | Displays whether the identified malfunction point judged by TCM is the related parts of high and low reversed clutch. |
| W/O THL POS | (ON/OFF) | X | - | O | Displays the kickdown condition signal status received via CAN communication. |
| CLSD THL POS | (ON/OFF) | X | - | O | Displays the idling status signal status received via CAN communication. |
| DRV CST JUDGE | (DRIVE/COAST) | - | - | O | Displays the judgment results of "driving" or "coasting" judged by TCM. |
| SHIFT IND SIGNAL | - | - | O | Displays the transmission value of shift position signal transmitted via CAN communication. | |
| STARTER RELAY | (ON/OFF) | - | - | O | Displays the command status from TCM to starter relay. |
| F-SAFE IND/L | (ON/OFF) | - | - | O | Displays the transmission status of A/T CHECK indicator lamp signal transmitted via CAN communication. |
| ATF WARN LAMP | (ON/OFF) | - | - |
|
|
| MANU MODE IND | (ON/OFF) | - | - | O | Displays the transmission status of manual mode signal transmitted via CAN communication. |
| ON OFF SOL MON | (ON/OFF) | - | - | O | Monitors the command value from TCM to the anti-interlock solenoid, and displays the monitor status. |
| START RLY MON | (ON/OFF) | - | - | O | Monitors the command value from TCM to the starter relay, and displays the monitor status. |
| ON OFF SOL | (ON/OFF) | - | - | O | Displays the command status from TCM to anti-interlock solenoid. |
| SLCT LVR POSI | - | X | O | Displays the shift positions recognized by TCM. | |
| GEAR | - | X | O | Displays the current transmission gear position recognized by TCM. | |
| NEXT GR POSI | - | - | O | Displays the target gear position of gear change that is calculated based on the vehicle speed information and throttle information. | |
| SHIFT MODE | - | - | O | Displays the transmission driving mode recognized by TCM. | |
| D/C PARTS | (FAIL/NOTFAIL) | - | - | O | Displays whether the identified malfunction point judged by TCM is the related parts of direct clutch. |
| FR/B PARTS | (FAIL/NOTFAIL) | - | - | O | Displays whether the identified malfunction point judged by TCM is the related parts of front brake. |
| 2346/B PARTS | (FAIL/NOTFAIL) | - | - | O | Displays whether the identified malfunction point judged by TCM is the related parts of 2346 brake. |
| 2346B/DC PARTS | (FAIL/NOTFAIL) | - | - | O | Displays whether the identified malfunction point judged by TCM is the related parts of 2346 brake or direct clutch. |
| N IDLE STATUS | (ON/OFF) | - | - | O | Displays the control status of idle neutral control. |
| SHIFT SCHEDULE | - | - | O | Displays the shift schedule selected by TCM. | |
| DRIVE MODE STATS | - | - | O | Displays the drive mode status recognized by TCM. | |
| SPORT MODE | - | - | O | Displays the status of drive mode select switch signal received via CAN communication. | |
| STANDARD MODE | - | - | O | ||
| ECO MODE | - | - | O | ||
| SNOW MODE | - | - | O | ||