Diagnosis Procedure

1. Turn ignition switch OFF.
2. Disconnect Power Window Motor (Driver Side) connector.
3. Turn ignition switch ON.
4. Check voltage between Power Window Motor (Driver Side) harness connector and ground.

   (+)		(-)	Condition		Voltage (V)
   Power Window Motor (Driver Side)
   Connector	Terminal
   D7	6	Ground	Power Window Main Switch	NEUTRAL	0 - 1
   				UP	9 - 16
   	3			NEUTRAL	0 - 1
   				DOWN	9 - 16

Is the inspection result normal?

YES 

Replace Power Window Motor (Driver Side). Refer to REMOVAL AND INSTALLATION .

NO 

GO TO STEP 2  .

1. Turn ignition switch OFF.
2. Disconnect Power Window Main Switch connector.
3. Check continuity between Power Window Main Switch harness connector and Power Window Motor (Driver Side) harness connector.

   Power Window Main Switch		Power Window Motor (Driver Side)		Continuity
   Connector	Terminal	Connector	Terminal
   D8	5	D7	3	Existed
   	6		6

4. Check continuity between Power Window Main Switch harness connector and ground.

   Power Window Main Switch		(-)	Continuity
   Connector	Terminal
   D8	5	Ground	Not existed
   	6

Is the inspection result normal?

YES 

Replace Power Window Main Switch. Refer to REMOVAL AND INSTALLATION .

NO 

Repair or replace harness.