Work Procedure: FPCM

With CONSULT

1. Turn Ignition Switch ON.
2. Select the "Re/programming, Configuration" of CONSULT.
3. Perform configuration according to the CONSULT display.

GO TO STEP 2  .

CONSULT Configuration

Select "CONFIGURATION" of FSCM.

When writing saved data 

GO TO STEP 3  .

CONSULT Configuration

Select "Before ECU Replacement". (If necessary)

GO TO STEP 4  .

CONSULT Configuration

Perform "Before ECU Replacement" according to the CONSULT display. (If necessary)

GO TO STEP 5  .

With CONSULT

1. Turn Ignition Switch ON.
2. Select the "Re/programming, Configuration" of CONSULT.
3. Select the "After ECU Replacement".
4. Select the "Manual Configuration". (If necessary)
5. Confirm and/or change setting value for each item.
6. Perform configuration according to the CONSULT display.

GO TO STEP 6  .

With CONSULT

1. Turn Ignition Switch OFF and wait for 10 seconds or more.
2. Turn Ignition Switch ON.
3. Perform self-diagnosis.
4. Check that no DTC is detected.

WORK END