Work Procedure
- REPLACE ELECTRONIC STABILITY PROGRAM CONTROL UNIT
Replace the electronic stability program control unit. Refer to Removal and Installation .
GO TO 2.
- WRITING VEHICLE SPECIFICATION
Perform the configuration. Refer to Description .
GO TO 3.
- CALIBRATION OF ACCELERATION SENSOR
Perform the calibration of acceleration sensor. Refer to Description .
GO TO 4.
- PERFORM VIN REGISTRATION
Perform the VIN REGISTRATION. Refer to Description .
GO TO 5.
- CHECK ALL ECU SELF-DIAGNOSIS RESULTS
- Erase all ECU self-diagnosis results using CONSULT.
- Turn the ignition switch OFF.
- Turn the ignition switch ON and wait for 2 seconds or more.
- Check that all ECU self-diagnosis results have no DTC.
WORK END