Data Monitor Mode

Monitor item (Unit)

Remarks

BATTERY VOLT (V)

Displays the power supply voltage for power steering control module.

STEERING ANGLE (deg)

Displays the steering angle based on the steering angle signal transmitted by CAN communications.

STR ANG SPD (deg/s)

Displays the steering angle speed based on the steering angle signal transmitted by CAN communications.

MOTOR CURRENT (A)

Displays the current value consumed by power steering control module.

MTR REV SPD COMM (rpm)

Displays the power steering motor speed command value.

MTR REV SPD (RPM)

Displays the power steering motor speed.

C/U TEMP (deg. C or deg. F)

Displays the temperature of the power steering control module.

C/U TEMP A (deg. C or deg. F)

Displays the temperature of the power steering control module.

MTR ASSIST (%)

Displays the current percentage of the allowable assist ratio power steering motor.

ESTM VHCL SPD (km/h or mph)

Displays the vehicle speed calculated by the power steering control module.

WARNING LAMP (On/Off)

Hydraulic pump electric power steering system warning lamp control status is displayed.

ENGINE STATUS (STOP/RUN/CRANK)

Engine speed is displayed from engine condition signal with CAN communication

VHCL SPD JUDGE (OK/NG)

Displays the receiving status of the vehicle speed signal transmitted by CAN communications.