Component Inspection

1. Turn ignition switch OFF.
2. Disconnect drive mode select switch harness connector.
3. Check the continuity between drive mode select switch terminals as follows.

   Drive mode select switch		Condition	Continuity
   +	-
   Terminals
   1	2	Switch to down-position.	Existed
   		Other than the above.	Not existed
   	3	Switch to up-position.	Existed
   		Other than the above.	Not existed

Is the inspection result normal?

YES

INSPECTION END

NO

Replace drive mode select switch. Refer to DRIVE MODE SELECT SWITCH : Removal & Installation .