Detailed Flow

Get the detailed information about symptom from customer.

GO TO 2.

CONSULT

1. Check DTC of "All DTC Reading".
2. Perform the following procedure if DTC is displayed.
   • Record DTC and freeze frame data. (Or, write it down.)
3. Check related service bulletins for information.

Is any DTCs detected?

YES

Perform the trouble diagnosis for DTC indicated.

NO

GO TO 3.

Try to confirm the symptom described by the customer.

Also study the normal operation related to the symptom. Refer to Handling Precaution .

GO TO 4.

Check drive mode switch circuit. Refer to Diagnosis Procedure .

Is inspection result normal?

YES

GO TO 5.

NO

Repair / replace harness or connector.

1. Ignition switch OFF and wait at least 10 seconds.
2. Ignition switch ON.
3. Check that STANDARD is displayed on the information display screen of the combination meter.
4. Check that the view of information display changes as STANDARD => SPORT => PERSONAL when switching the drive mode switch to up side.
5. Check that the view of information display changes as PERSONAL => SPORT => STANDARD => ECO when switching the drive mode switch to down side.

Is the inspection result normal?

YES

INSPECTION END

NO

Check intermittent incident. Refer to Intermittent Incident .