LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Isuzu >> 1997 >> Trooper LS >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Basic Testing >> Trouble Shooting >> Mil On Steady
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Mil On Steady

  1. Perform On-Board Diagnostic (OBD) System Check. See ON-BOARD DIAGNOSTIC (OBD) SYSTEM CHECK  . After performing OBD system check, go to next step.
  2. Turn ignition off. Disconnect PCM C-1 electrical connector. Turn ignition on. If MIL comes on, go to next step. If MIL does not come on, go to step 5).
  3. Turn ignition off. Disconnect instrument panel cluster connector. Check for short to ground in MIL control circuit (Purple wire) between PCM connector C-1 terminal A13 and instrument panel cluster. Repair as necessary. Repeat ON-BOARD DIAGNOSTIC (OBD) SYSTEM CHECK  . If circuit is okay, go to next step.
  4. Replace instrument panel cluster. See appropriate INSTRUMENT PANEL article in the instrument panel section. Repeat ON-BOARD DIAGNOSTIC (OBD) SYSTEM CHECK  .
  5. Turn ignition off. Reconnect PCM C-1 electrical connector. Turn ignition on. Reprogram EEPROM. Using scan tool, command MIL OFF. If MIL did not go off, go to next step. If MIL did go off, repeat ON-BOARD DIAGNOSTIC (OBD) SYSTEM CHECK  .
  6. Replace PCM. Repeat ON-BOARD DIAGNOSTIC (OBD) SYSTEM CHECK  .
scientia non olet · About LEMON Manuals