SLX & Trooper
- Check C-4 ELEC IGN fuse (15-amp) located in dash fuse box. If fuse is okay, go to next step. If fuse is blown, replace fuse and recheck system operation.
- Use DVOM and check continuity of C/B-2 (P/W, P/S, S/R) circuit breaker located in dash fuse box. If circuit breaker is okay, go to next step. If circuit breaker tests bad, replace and recheck system operation.
- Ensure ground connection B-19 is secure. Refer to COMPONENT LOCATIONS . Repair if necessary. If ground connection is okay, go to next step.
- Disconnect power window relay located in dash fuse box. Use DVOM and measure voltage between ground and power window relay cavity terminal No. 2 (Black/Blue wire). See WIRING DIAGRAMS . If battery voltage is indicated, go to step 6). If battery voltage is not indicated, go to next step.
- Repair open in Black/Blue wire between C/B-2 circuit breaker and power window relay located in dash fuse box. See WIRING DIAGRAMS . After repairs, go to step 4).
- Turn ignition switch to ON position. Use DVOM and measure voltage between ground and power window relay cavity terminal No. 1 (Blue/White wire). See WIRING DIAGRAMS . If battery voltage is indicated, go to step 8). If battery voltage is not indicated, go to next step.
- Repair open in Blue/White wire between C-4 ELEC IGN fuse and power window relay located in dash fuse box. See WIRING DIAGRAMS . After repairs, repeat step 6).
- Use DVOM to check for continuity between ground and power window relay cavity terminal No. 3 (Black wire). If continuity is indicated, replace power window relay. If continuity is not indicated, go to next step.
- Repair open in Black wire between ground connection B-19 and power window relay located in dash fuse box. See COMPONENT LOCATIONS . After repairs, recheck system operation.