Front Window Regulator, Glass And Glass Run: Installation

To install, follow the removal steps in the reverse order, noting the following points.

1. Apply soap and water to the door frame groove. Insert the glass run (1) to the door frame from the A corner in the arrow-marked directions.

   Install the glass run with its wider end pointed to the inside of the vehicle.

   Fig 1: Identifying Glass Run

   Courtesy of ISUZU MOTOR CO.
2. Set the glass into the door panel with the front side of the glass lowered and insert the rear side of the glass into the glass run (1). Then insert the front side of the glass into the glass run in order to install the glass to the glass run while raising it up along the glass run.
3. Tighten the window regulator and the glass fixing bolts and nuts to the specified torque.

   Torque:  8 N.m (69 lb in)

4. Check to see of the window regulator operates smoothly and the glass opens and closes properly. Install the waterproof sheet with no clearance between the door panel and the waterproof sheet.