Power Steering Unit: Reassembly
- Install mounting rubber and dust cover (If removed).
- Install oil line.
Torque: 13 N.m (113 lb in)
- Install tie-rod assembly with tab washer.
Apply grease to ball joint, install tie-rod and tab washer, then tighten to specified torque.
Torque: 83 N.m (61 lb ft)
After tightening, bend tab washer against width across flat of inner ball joint.
- Apply a thin coat of grease to the shaft for smooth installation. Then install bellows.
- Install band and clip.
- Install tie-rod end and tighten lock nut.
Torque: 98 N.m (72 lb ft)