LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Isuzu >> 2003 >> Axiom Base, 4WD >> Repair and Diagnosis >> Engine Performance >> Engine Controls - On-Vehicle Adjustments >> Transmission Mode Switch >> Method No. 2
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Method No. 2

  1. Place transmission selector lever in Neutral. Remove selector lever from automatic transmission mode switch. Remove cover from mode switch.
  2. Disconnect mode switch 6-pin harness connector and bracket from transmission. With DVOM set to read resistance, connect DVOM between mode switch pins No. 1(E) and 4(H). See Fig 1 .
  3. Loosen (2) 10-mm screws securing mode switch. Rotate mode switch slightly in both directions (about 5 degrees) to determine range of electrical contact.
  4. Position mode switch in middle of contact range. Tighten mode switch retaining bolts to 113 INCH lbs. (13 N.m). Remove DVOM. Install harness connector.
  5. Install shift lever on mode switch and tighten shift lever nut. Install mode switch cover on gear position switch. Install heat protector.
Fig 1: Identifying Transmission Mode Switch Terminals
G00141538Courtesy of ISUZU MOTOR CO.
scientia non olet · About LEMON Manuals