Rear Door Lock Assembly

Removal

1. Disconnect the battery ground cable.
2. Remove the rear corner garnish.
- Pull the corner garnish to disconnect the retaining clip.

3. Remove window regulator handle.




- Remove the clip on the rear side of the regulator handle using a wire.

4. Remove the screw while pulling the inside lever toward you and then remove the inside handle.




5. Remove the screw at the pull case.
6. Pull out the trim panel at the 8 clip positions.




- Disconnect the power window switch connector.

7. Remove the bracket.
8. Peel the upper half of the waterproof sheet.
- Taking notice of the door harness, peel the waterproof sheet off the door panel carefully.




9. Disconnect the locking links and remove the door lock assembly fixing screws to remove the door lock assembly.

Installation

To install, follow the removal steps in the reverse order, noting the following points.

1. Apply chassis grease to the lock assembly and striker moving surface.




2. Install the regulator handle as shown in the illustration, if equipped without power windows.
3. Tighten the door lock assembly fixing screws to the specified torque.

Torque: 7 N.m (61 lb in)

4. Check that the door lock operates smoothly.